Aircrack-ng - airodump-ng cannot find AP
by Teso from LinuxQuestions.org on (#55YT0)
Hello,
I installed "aircrack-ng-1.6" from source code on Kubuntu 19.10.
i'm not sure if i compiled everything correctly.
I have read the "README" file and this only says to run "./configure". That didn't work, I had to run "./autogen.sh" first and then "./configure" and "make && make install"
The "README" file is unusable and I can't find any instructions on how to properly install the source code.
But maybe I did everything right and it is simple that the network interface controller is not supported. I also tried a new firmware for the NIC "firmware-6.bin_WLAN.RM.4.4.1.c3-00075".
Airodump-ng is not showing any "Wi-Fi Access Points" on any channel, it shows just a empty table, is scanning but cant find nothing.
Network interface controller:
Qualcomm Atheros QCA6174 802.11ac Wireless Network Adapter (rev 32)
I installed "aircrack-ng-1.6" from source code on Kubuntu 19.10.
i'm not sure if i compiled everything correctly.
I have read the "README" file and this only says to run "./configure". That didn't work, I had to run "./autogen.sh" first and then "./configure" and "make && make install"
The "README" file is unusable and I can't find any instructions on how to properly install the source code.
But maybe I did everything right and it is simple that the network interface controller is not supported. I also tried a new firmware for the NIC "firmware-6.bin_WLAN.RM.4.4.1.c3-00075".
Airodump-ng is not showing any "Wi-Fi Access Points" on any channel, it shows just a empty table, is scanning but cant find nothing.
Network interface controller:
Qualcomm Atheros QCA6174 802.11ac Wireless Network Adapter (rev 32)