Icom RS-BA1: Setting up the IC-7300 for remote operation

(Source: Southgate ARC and Dave Zantow)

New video: Icom RS-BA1. Installing & setting-up remote control for your IC-7300

The TX Factor have produced a video that logically goes through the step by step process of remote controlling an Icom Amateur radio, more specifically in this case, the IC-7300 using the RS-BA1 remote control software.

The video shows Bob McCreadie (G0FGX) of TX Films demonstrating:

" Setting up your computer and radio
" Installing the RS-BA1 remote control software
" Accessing the IC-7300 remotely
" Introduction to the RC-28 remote controller encoder.

To view this video visit:
Icom RS-BA1. Installing & Setting up Remote Control for your IC-7300 SDR Radio

To found out more about Icom's remote control software, visit the
RC-28 IP Remote Control System page where you will also find a list of compatible Icom HF radios.

For more information about the IC-7300 visit the
IC-7300 HF/50/70MHz Transceiver product page.

Both the RC-28 IP Remote Control System and IC-7300 are available from all authorised Icom Amateur radio dealers.

Of course, you could use the RS-BA1software to use the Icom IC-7300 as a remote shortwave receiver. Click here to read our review of the IC-7300.