3D Printing Question.
by business_kid from LinuxQuestions.org on (#5CBSA)
I'm running up a curved surface for 3d printing. Have I got the orientations correct for a 3d printer?
I'm using FreeCad, did a 2D sketch in XZ orientation, then padded it (in Y) all using the "Front" view. Then when I move to top view, I get this:
Link to SVG Image on mega.nz which is hopefully X,Y, & Z in the correct places.
If it's not correct, what should I have done?
I'm using FreeCad, did a 2D sketch in XZ orientation, then padded it (in Y) all using the "Front" view. Then when I move to top view, I get this:
Link to SVG Image on mega.nz which is hopefully X,Y, & Z in the correct places.
If it's not correct, what should I have done?