Canon G3000 series with common cups driver
by dashh from LinuxQuestions.org on (#5K9D0)
Hello Folks,
Although I'm aware of that Canon is providing a closed source binary driver for this printer I want to set it up on a raspberry pi which is ARM architecture not X64 so that won't work.
I wonder if anyone succeeded with some generic driver for these to print through CUPS.
Code:Not shown: 997 closed ports
PORT STATE SERVICE
80/tcp open http
443/tcp open https
515/tcp open printer
Although I'm aware of that Canon is providing a closed source binary driver for this printer I want to set it up on a raspberry pi which is ARM architecture not X64 so that won't work.
I wonder if anyone succeeded with some generic driver for these to print through CUPS.
Code:Not shown: 997 closed ports
PORT STATE SERVICE
80/tcp open http
443/tcp open https
515/tcp open printer