[SOLVED] F2FS and LILO
by Jeebizz from LinuxQuestions.org on (#5RJHA)
So in a VM of course, I decided to do a dry-run of f2fs (--Current of course) - given that I am using a SSD(SATA , not NVME though) , I set all the partitions as f2fs.
Code:/boot ~ 300MM
/ ~ 63GB
/home ~ 153GB
swap ~ 32GBWhen getting to the point of installing LILO is where I run into trouble, I select where Linux is installed and then LILO freaks out..
Attachment 37634 Attachment 37635 Attachment 37636 Attachment 37637
I know perhaps a while back a similar thread might have been created, but I don't recall nor what the work-around solution is.
Is this a limitation with lilo or f2fs , or both as they just seem to not play nice with each other? What is the suggestion on getting this to work as I would love to have my SSD just run f2fs partitions (with a swap of course). :scratch:
Attached Thumbnails
Code:/boot ~ 300MM
/ ~ 63GB
/home ~ 153GB
swap ~ 32GBWhen getting to the point of installing LILO is where I run into trouble, I select where Linux is installed and then LILO freaks out..
Attachment 37634 Attachment 37635 Attachment 37636 Attachment 37637
I know perhaps a while back a similar thread might have been created, but I don't recall nor what the work-around solution is.
Is this a limitation with lilo or f2fs , or both as they just seem to not play nice with each other? What is the suggestion on getting this to work as I would love to have my SSD just run f2fs partitions (with a swap of course). :scratch:
Attached Thumbnails