Is the new wifi rtw88_8822bu module stable for AP mode?

Hi everybody,

The module rtw88_8822bu module is available from kernel 6.x (6.3 or 6.5).

This module was seemingly written by Realtek... (based on 6.5 source)

There are however problems in the longer term (meaning, after the system is up for a few hours)
from dmesg

Code:[19639.053078] rtw_8822bu 1-8.4:1.0: error beacon valid
[19639.053184] rtw_8822bu 1-8.4:1.0: failed to download rsvd page
[19639.053343] rtw_8822bu 1-8.4:1.0: failed to download firmware
[19639.054903] rtw_8822bu 1-8.4:1.0: leave idle state failed
[19639.059143] rtw_8822bu 1-8.4:1.0: failed to leave ips state
[19639.059145] rtw_8822bu 1-8.4:1.0: failed to leave idle state
[19639.222254] rtw_8822bu 1-8.4:1.0: failed to get tx report from firmware
[19647.499717] rtw_8822bu 1-8.4:1.0: failed to send h2c commandDoes anybody know if this module works also reliably in AP (Access-Point) mode?

Thanks