Mashing May Mitigate Mars Mole Meandering
RandomFactor writes:
NASA engineers are preparing another tactic to get the troubled "mole" instrument on the Mars InSight lander burrowing into the regolith as intended.
Engineers plan to use the robotic arm on its InSight Mars lander to push a heat flow probe into the surface, acknowledging that they have "few alternatives" if that effort fails.
The Heat Flow and Physical Properties Package instrument team has spent nearly a year trying to get the instrument's probe, or "mole," to burrow into the surface. The mole has an internal hammering mechanism that is designed to drive the probe as deep as five meters into the surface in order to measure the heat flow from the planet's interior.
The mole, though, stopped only about 30 centimeters below the surface. The mission has tried a number of ways to get the mole moving again, including removing the instrument housing on the surface to allow the lander's robotic arm to try and fill in the hole created by the mole, as well as pin the mole to one side of that hole, increasing the friction needed for the mole to work its way into the surface.
In October, that use of the arm to pin the mole worked briefly, allowing the mole to burrow into the surface, only for it to rebound partially out of the hole. A second attempt led to the mole again rebounding partially out of the hole in January.
The mole is a 16-inch-long (40-centimeter) spike equipped with an internal hammering mechanism that relies on friction from the soil to help it dig down. The probe is designed to drag a ribbon-cable like tether behind it as it digs.
While pushing down on the top (back cap) of the probe seems an obvious approach, according to NASA "The team has avoided pushing on the back cap until now to avoid any potential damage to the tether."
Previous Coverage
More Mars Mole Mission Misfortune
Mars Mole Mission Rues Resistanceless Regolith
NASA to Jack up Insight Lander to Assess Non-Penetrating Probe
InSight Impinges Insufficiently in Site
Also at NASA-JPL
Read more of this story at SoylentNews.