Using laser-etching, scientists design intensely hydrophobic, self-cleaning material

by
in science on (#2WSX)
Scientists have created a new water-hating material by laser-etching a microscopic pattern on a metal surface. The surface could be used for everything from preventing ice from developing on airplane wings to creating self-cleaning toilets. And unlike traditional chemical coatings, the new material will not wear off, the researchers say.

It's much more repellent than typical chemical coatings, like the Teflon in nonstick frying pans. Teflon-coated surfaces need to be tilted at nearly a 70-degree angle before a water droplet will slide off, whereas the new material only needs to be tilted at less than 5 degrees, the researchers reported in the Journal of Applied Physics. To create the new material, Guo and his colleagues used powerful, but very short, laser pulses to etch a platinum, titanium or brass surface. Currently, it takes an hour to etch a 1 inch by 1 inch (2.5 by 2.5 centimeters) piece of metal, so this process needs to be sped up.

wear off? (Score: 1)

by billshooterofbul@pipedot.org on 2015-01-26 23:29 (#2WSY)

As in will not fall off?

Or

As in will not stop working?

The former makes a lot of sense, and is quite obvious. The latter is an interesting claim. Is it really difficult to damage the etching's properties? Can I take a sharp knife to the finish over and over again without damaging the finish?

Also, is it oil proof? Most of what I cook has some of that too. IF its impervious to water souluble messes and sucks at oil, well thats better than nothing, but not worth much.
Post Comment
Subject
Comment
Captcha
What is seventy seven thousand nine hundred and six as a number?